The eddy current equipment is composed of two parts: control and main body. The main part mainly consists of frame, motor, distributor, separator (the core part of the equipment) permanent magnetic drum, conveyor belt, conveyor drive drum, reducer and protective cover.

1. Simple operation, automatic separation of metal and non-metal; reliable single power design, making the system compact and reliable;

2. The span of separable metal particles is large, usually between 3mm and 100mm;

3. Easy to install, customized according to the customer's needs, can be effectively connected with the new and existing assembly line;

4. Using high gradient rare earth permanent magnet system, the energy consumption is low and the maintenance is convenient;

5. According to the different turning direction of the rotor, different size materials can be sorted;

6. Various models are available (the width of the material tray can be 300 mm to 1500 mm).

Eddy Current Separator Applicance After being broken by the crusher, the municipal domestic waste, industrial waste, electronic waste, glass scraps, waste plastic doors and windows, urban wood waste, boiler bottom ash, various metal mixtures, recycling of copper, aluminum and other non-ferrous metals in the waste automobile (after being sliced by the shredder), and material treatment and sorting in the environmental protection industry.

Eccentric Eddy Current Separator For Sorting Waste Scraps And Flakes With Non-ferrous Metal Aluminum And Copper Eddy Current Separator can be widely used in the field of environmental protection such as waste disposal, waste electrical appliances recycling and non-ferrous metal processing industry. The non-ferrous metals are recovered from the crushing materials of the automobile dismantling plant, from the copper aluminum casting sand and smelting ash, and from the waste motor crushing materials; the non-ferrous metals are recovered from the incinerated printed circuit board, from the domestic waste, industrial
waste, electronic waste treatment, waste plastic doors and windows, boiler bottom ash and other non-ferrous metals.

Eddy current separator maintenance instructions
1. Check and tidy up in time. Clean the machine at the end of each day. Check whether the screws of each part are loose or there are worn parts, such as claws and screens.
2. Fill with grease, usually install the cap oil cup on the bearing. Under normal circumstances, as long as the oil cup cover rotates 1 / 4 turn every 2 hours, the grease in the cup can be pressed into the bearing. For closed bearings, grease can be added every 300 hours. After long-term use, if the grease is replaced, clean the bearing and replace with new grease. When the equipment
is working, the temperature of the bearing shall not exceed 40 ° C. If the bearing temperature continues to rise under normal operating conditions, the cause should be found and the fault resolved.
3. Carefully clean the material to be damaged. It is forbidden to mix copper, iron, lead and other metal parts, large stones and other sundries into the damage room.